VibraSens - Your European Piezoelectric Vibration sensors manufacturer - Vibration Sensor Curved Magnet Model 221.01

Main Menu

User Menu

Polls

What is your preferred connector for accelerometers

	European M12
	American Mil-C-5015
	Integral cable
	Don't care

NEWSFLASH - New Magnet bases
May 2, 2008

VibraSens has just released his new line of magnet bases.
The use of magnet bases is convenient and quick for many route measurements.
All type of Magnet bases are available : for flat or curved surface and for top or side connector.
Our bases use rare earth high temperature grade magnet. They could therefore be used in very hot section up to 150°c like for example pulp and paper mill dryer section.
Rare earth magnet gives a strong pull force as high as 23 kg (50 Pounds).
All products are now available from stock.

If you have any questions, comments or concerns please use the Contact Us feature.

Vibration Sensor Curved Magnet Model 221.01

portable route measurements
high temperature up to 150°C
for top connector sensors with M6 and 1/4" 28 UNF thread

Datasheet 221.01

This is the most usual method of accelerometer mounting. These studs are detachable, permitting rapid, low cost replacement. They are used by most accelerometer manufacturers but they are not fully compatible due to the shoulder diameter and the thread length.You should not use ordinary machine screws. They lack a flange or shoulder and might bottom in the accelerometer degrading his dynamic response.

< Prev

[ Back ]